Beaver on water? FSX

Go to any airport near a coast and select your amphibian. It will be placed
at the start of a runway. Then press Y to slew and F4 to rise upwards. Press
Y again and you will be flying. Land on the water where you want to be and
save the flight.

Quilly
 >> Stay informed about: Beaver on water? FSX 

Or easier yet select your aircraft, go to the map mode and drag the plane
with the mouse to anywhere you want it.

"Mac" <macone RemoveThis @vianet.on.ca> wrote in message
news:12qf5ivig84sc17@corp.supernews.com...
> How do I get the De Haviland Beaver,a fixed float aircraft,to start a
> flight on water?
> I have searched bunches of start locations in Canada,specifically
> Ontario,and ALL place the craft on solid ground,runways and ramps etc.Am
> I an idiot?
> Thanx
>
 >> Stay informed about: Beaver on water? FSX 

On Fri, 12 Jan 2007 14:43:38 -0000, Quilljar wrote:

> Then press Y to slew

Thank you worthy slewmaster.



--
>>> Dallas <<<
 >> Stay informed about: Beaver on water? FSX 

"Mac" <macone.DeleteThis@vianet.on.ca> wrote in message
news:12qf5ivig84sc17@corp.supernews.com...
> How do I get the De Haviland Beaver,a fixed float aircraft,to start a
> flight on water?
> I have searched bunches of start locations in Canada,specifically
> Ontario,and ALL place the craft on solid ground,runways and ramps etc.Am
> I an idiot?
> Thanx

I asked the same question a few months back. The sectionals show a distinct
symbol for seabases. If you have Deluxe, install the SDK and enable the
Tools menu. One of the tools is an airport dumper. It dumps a textual list
of all airports in the database, and describes each runway. Seabases have
water runways, rather than hard or soft. In theory, you could find every
airport with water runways, and pick the one you want. I gave up on
amphibians at this point...
 >> Stay informed about: Beaver on water? FSX